The Shop > Tools

6" Vertex rotary table problem

<< < (3/3)

Bluechip:
No idea if this is relevant to this thread or not but I have a 6" 4-slot Vertex RT.
Made in Taiwan, had it for about 20 yrs.
The 2MT socket presses out on mine.Could the  removed socket then be set up in a 4-jaw and bored ?
Or have I got this ALL wrong again. Has been known.  :thumbup:
Dave

picclock:
@ Bluechip
I hope it is, but I have yet to disassemble the table. Looking at the underneath it appears to all be in 1 piece. I had also thought of boring it out parallel and fitting an MT2 socket which I have in my parts box, think it might have been part of an adapter. But, I'm not sure how much meat will be left on the table if I do that.

Best Regards

picclock

Navigation

[0] Message Index

[*] Previous page