| The Shop > Tools |
| 6" Vertex rotary table problem |
| << < (3/3) |
| Bluechip:
No idea if this is relevant to this thread or not but I have a 6" 4-slot Vertex RT. Made in Taiwan, had it for about 20 yrs. The 2MT socket presses out on mine.Could the removed socket then be set up in a 4-jaw and bored ? Or have I got this ALL wrong again. Has been known. :thumbup: Dave |
| picclock:
@ Bluechip I hope it is, but I have yet to disassemble the table. Looking at the underneath it appears to all be in 1 piece. I had also thought of boring it out parallel and fitting an MT2 socket which I have in my parts box, think it might have been part of an adapter. But, I'm not sure how much meat will be left on the table if I do that. Best Regards picclock |
| Navigation |
| Message Index |
| Previous page |