Gallery, Projects and General > Member Videos

foundry work - aluminum pulley

(1/2) > >>

celsoari:
Step by step how I build an aluminum pulley



Greetings from Brazil


Celso Ari

tom osselton:
 :thumbup:

SwarfnStuff:
Thank you for showing the making of the pulley from rough pattern to finished pulley. Steps were simply shown in minimum of time but I was able to follow your process.
Thanks again,
John B   :thumbup: :med:

celsoari:

--- Quote from: SwarfnStuff on February 01, 2020, 11:05:14 PM ---Thank you for showing the making of the pulley from rough pattern to finished pulley. Steps were simply shown in minimum of time but I was able to follow your process.
Thanks again,
John B   :thumbup: :med:

--- End quote ---


--- Quote from: tom osselton on February 01, 2020, 07:16:28 PM --- :thumbup:

--- End quote ---

thanks Bros,  greetings from Brazil

shipto:
Very good although I did shudder a little at your bandsaw use  :bugeye:

Navigation

[0] Message Index

[#] Next page