| Gallery, Projects and General > Project Logs |
| Re-Pimping the 7x12 minlathe. |
| << < (6/11) > >> |
| RotarySMP:
In Episode 12, I'm using the LinuxCNC converted MAHO 400E to convert to tapered gibs on the saddle. Mark |
| RotarySMP:
Just uploaded episode 13... Mark |
| RotarySMP:
Now that the geometry of the main components has been corrected, we can move on to the motion hardware... |
| RotarySMP:
Epispde 15 is now up, which covers the spindle motor, and has a bit of Maho slotting head action. |
| RotarySMP:
I was too embarrassed by last weeks screw up to post a link to Episode 17... but Episode 18 is back to normal. Mark |
| Navigation |
| Message Index |
| Next page |
| Previous page |