Gallery, Projects and General > Neat Stuff

How-to: X2 Mini Mill Torque and Speed increase

<< < (5/6) > >>

j.bain87:
To NorthOf40, sorry for the delay, if you could try -   j.bain87@yahoo.com  -  it would be appreciated.

regards  John.

Stilldrillin:
Did I read somewhere, the Conquest bearings are the same set, both for mill & lathe?  :scratch:

ie. The lathe taper bearings (30206) fit the mill......   :thumbup:

David D

John Rudd:
I can confirm that the original 6206 bearings fitted to my minimill have the following dimensions:

ID 30
OD 62
Depth 16

All dims in mm.

Equivalent Taper brgs are SKF 30206

Dimensions are:

ID 30
OD 62
Depth 17.5

I have these fitted to my Chester Conquest mill, the version I have is not the current version they sell but is similar to the Warco minimill.

Hope this helps


John

NorthOf40:

--- Quote from: j.bain87 on July 01, 2009, 02:24:50 AM ---To NorthOf40, sorry for the delay, if you could try -   j.bain87@yahoo.com  -  it would be appreciated.

regards  John.

--- End quote ---

On the way :thumbup:

j.bain87:
Arrived safely, thank you very much NorthOf40.

Navigation

[0] Message Index

[#] Next page

[*] Previous page