Gallery, Projects and General > How do I?? |
making fine indexing marks? |
(1/3) > >> |
picclock:
I need to make some very fine indexing / calibration marks in steel. Ideally the thickness should be about the same as on the half mm divisions on an engineers rule ~ 0.1mm thick. Does anyone know how this is done ? My best thought is some form of etching, but not sure how this is achieved. My desperate thought is to butcher a cheapo 6" rule and fit the remains in a recess. Any thoughts or ideas much appreciated. Best Regards picclock |
Lew_Merrick_PE:
Hi Picclock --- There are finely tapered engraving tools with which I have had good results making .005 inch marks for "alignment guides" over the years. Here in the US they run (about) USD 15. I probably have 2 or 3 sitting in my "strange bit" cutter bar. -- Lew |
Pete.:
I made one in a pinch from a broken carbide end mill. I ground the tip to a fine point then ground one side flat. Made a super-sharp engraving tool. |
awemawson:
Dip subject piece in melted wax to form a thin layer. When hard index an ordinary sewing needle or pin in the shape of your engraving lines. Dip in the etchant of your choice depending on material of subject. . . . warm to remove wax . . stand back and admire your fine lines :clap: |
picclock:
Hi Thanks for the interest and ideas. Ideally I would like a bit to fit in the mill as then I can use the scales to get accurate positioning. I have tried looking for a fine engraving bit but have found none suitable for steel in the uk. Will keep an eye out though as I think this would be a good solution. I have had an idea which might pan out. By rotating the mill head so the cutter is at 45 degrees I could use corner of a small carbide end mill to cut a V groove of a suitable size. I have a 3mm endmill in carbide and some smaller ones in hss, but the carbide one may do the trick. I'll give it a try and post pictures if successful. Many Thanks for your interest. Best Regards picclock |
Navigation |
Message Index |
Next page |