Author Topic: Manual tool change help ddcsv  (Read 3330 times)

Offline tonyho810

  • Newbie
  • *
  • Posts: 3
Manual tool change help ddcsv
« on: November 26, 2019, 12:07:53 PM »
Hi,

Can anyone help please. I'm trying to do a manual tool change on my home made router driven by ddcsv2.1. I'm using Fusion360 and trying various post processors.  As far as I can work it out the post inserts M06 in the code and the ddcsv goes off and runs the t.nc macro. Is that correct? I'm stuck with the t.nc macro, what do i put in it? If someone has already generated on could you share it please? I put a post on the official forum but no response.

Thanks,

Tony

Offline Will_D

  • Hero Member
  • *****
  • Posts: 668
  • Country: ie
    • National Homebrew Club of Ireland
Re: Manual tool change help ddcsv
« Reply #1 on: November 27, 2019, 04:54:53 AM »
Please read this:
Engineer and Chemist to the NHC.ie
http://www.nationalhomebrewclub.ie/forum/

Offline Will_D

  • Hero Member
  • *****
  • Posts: 668
  • Country: ie
    • National Homebrew Club of Ireland
Re: Manual tool change help ddcsv
« Reply #2 on: November 27, 2019, 04:57:08 AM »
I should include more about T.nc in that file, but here is what it contains:

G04P0
M110
G91 G92 Z#[767+#592]-#[767+#593]
#592 = #593

Hope this helps

Will
Engineer and Chemist to the NHC.ie
http://www.nationalhomebrewclub.ie/forum/

Offline Will_D

  • Hero Member
  • *****
  • Posts: 668
  • Country: ie
    • National Homebrew Club of Ireland
Re: Manual tool change help ddcsv
« Reply #3 on: November 27, 2019, 05:34:40 AM »
There is also a Facebook group that is pretty responsive

https://www.facebook.com/groups/1724999967517167

Here you will in the files section the latest user manual and a version description document as well as other useful stuff

Will


Engineer and Chemist to the NHC.ie
http://www.nationalhomebrewclub.ie/forum/

Offline tonyho810

  • Newbie
  • *
  • Posts: 3
Re: Manual tool change help ddcsv
« Reply #4 on: November 27, 2019, 06:18:51 AM »
Thanks Will,

I rememered in the middle of the night that  unix is case sensitive and I had been using t.nc instead of T.nc. That combined with the code you posted will fix it I'm sure

Thanks again,

Tony