| Gallery, Projects and General > Project Logs |
| David's Mini Lathe...... |
| << < (4/9) > >> |
| John Rudd:
David, The two wires connected to the speed control board at the Line In terminals, can you disconnect them from the board, then: 1) measure the resistance across the L and N pins of the mains plug ( do this with E stop in its normal state) ( this will determine if there is a fault in the incoming wiring stuff) 2) measure the resistance across the two Line In terminals on the speed control board... |
| Stilldrillin:
John. Wires disconnected. Meter across plug pins... No reaction. Meter across, the two terminals. Needle fully over, reading zero. |
| John Rudd:
David looks like theres an issue with the board then... Would you like me to look at it and effect a repair? :zap: ( I just checked, a new board is £132... From Arc..Ouch, didnt think they were that much...) |
| Stilldrillin:
Please John. I certainly would! It's a pity, I can't fit one of the spares, you repaired last year..... No rush. I'll detach, and box it up, over the weekend. Thanks for your input. I've enjoyed this little fault finding exercise..... |
| John Rudd:
Do you have my current address? I'll message it to you... I dont live in Hull anymore..... Why cant you fit one of the others? Are these the KB boards? |
| Navigation |
| Message Index |
| Next page |
| Previous page |