Gallery, Projects and General > Member Videos
QCTP
celsoari:
I was just wanting to build one, I hope you enjoy the video
Celso Ari
tom osselton:
Very nice tool post!
jim:
Good work
AdeV:
Nicely done!
I'm curious though - why didn't you rough out the dovetails on the shaper? Seems it would have been perfect for that job, and a lot less stressful than trying to keep the dovetail cutters in good condition which, as I found when I did my QCTP & toolholders, means lots of slow tedious light cuts...
I plan to make more toolholders for mine, and I'll definitely be doing them on the shaper!
celsoari:
--- Quote from: AdeV on September 28, 2019, 03:40:45 AM ---Nicely done!
I'm curious though - why didn't you rough out the dovetails on the shaper? Seems it would have been perfect for that job, and a lot less stressful than trying to keep the dovetail cutters in good condition which, as I found when I did my QCTP & toolholders, means lots of slow tedious light cuts...
I plan to make more toolholders for mine, and I'll definitely be doing them on the shaper!
--- End quote ---
73/5000
I don't have much shaper skill yet.
I am learning to use it
greetings from Brazil
Celso Ari
Navigation
[0] Message Index
[#] Next page
Go to full version