| Gallery, Projects and General > Gallery |
| Tool post grinder build Clough42 inspired |
| << < (2/10) > >> |
| chipenter:
My tool post grinder has two ribs on a 1425 rpm motor geared up 4 to 1 with a 25mm diameter pully , and not had any problems using a 50mm grinding wheel . |
| PekkaNF:
--- Quote from: chipenter on September 03, 2019, 10:13:51 AM ---My tool post grinder has two ribs on a 1425 rpm motor geared up 4 to 1 with a 25mm diameter pully , and not had any problems using a 50mm grinding wheel . --- End quote --- Thank you. J-profile belt? How big motor in wats? |
| chipenter:
It's a small motor MadModder » Gallery, Projects and General » Project Logs » Cheepo toolpost grinder and uses a ER16 collet chuck . |
| PekkaNF:
Hi Jeff, Found it: https://madmodder.net/index.php/topic,10078.0.html How does it works? What is the story with the slits at the front of the bearing seat? I like the grinding wheel guard. |
| chipenter:
That's the piece that hold the bearing in parted off the cuts are on the outside to screw it in . |
| Navigation |
| Message Index |
| Next page |
| Previous page |