And a fine job it is.
If you are feeling particularly energetic I suggest pulling the linkage cover off from behind the fine feed knob and having a look at the shaft. I don't know why they felt the need to use a u-joint there. I replaced mine with a solid shaft and it eliminated 90% of my fine feed backlash.
Thanks for that Todd!
I have just been fine tuning the shaft/ front bearing alignment.
The bearing block is vertical, with the shaft heading slightly downhill to it`s wormwheel end. I elongated the hole slightly.
The u-j is firm, backlash free......
Drilled a couple of proving holes ........ Much improved!

David D