Gallery, Projects and General > The Design Shop
Miniatyre portable smoke machine - green smoke?
PekkaNF:
Found some nicrome wire home, most promising is N70 OD 0,83 mm 2,2 ohm/m.
Found calculator that gives some promising results.
https://www.steam-engine.org/coil.html?mat=n70&r=0.8&dia=0.83&id=10.11&ll=20.1
tom osselton:
Couldn’t you use a diesel glow plug they heat almost instantly I’ve got six on my shelf that I have been thinking about for heating things.
awemawson:
Or a Thermostart as used in Diesel engines in the inlet manifold. They have a heater coil AND a small valve that opens letting diesel flow from a small tank which could contain your smoke fluid.
Will_D:
Pekka,
Would these be of interest?
http://www.smokemachines.net/coloured-smoke.shtml
NJoy, Will
PekkaNF:
Thank you,
Tom, Interesting idea, but I think that capacity would be low
Andrew, that actually burns the fuel and therefore would be risky. Have to have a look on one after a week. My father has few old Massey Ferguson 35. maybe there is something to learn.
Will, " UK delivery only." They are pyrotechnics, ok of photography, but not great on public show.
http://www.smokemachines.net/smoke-pellets.shtml
I ahve been strugling to calculating/estimating the proper amount of power and size of the heater coil. Tables show very much lower current to reach the set temperature than calculator above. Have to do a little more reading and then experiment to see how numbers add up to experiment. Unknow is the amount of energy used to evaporate the smoke fluid, test is in order.
Pekka
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version