Gallery, Projects and General > How do I??
Cutting round grooves in wheels ? Bogstandard's method ?
(1/1)
HappyBill:
Hello,

I was looking at a writeup of making George Britnell's tube bender and saw this sentence

I made the needed parts for 2, 4 and 6 mm tubing, I did the grooves with a rotary table and mill, the way Bogstandard suggested in another tubing bender post. An excellent, fast method to get the size just right.

I have done some searching but cannot find that post - can anybody point me to that method please ?

Bill
PekkaNF:
Can't remember that post, but I "think" that this method might be RT (with a round blank centered and mounted on table) upright/vertical and ordinary correct diameter end mill cutting tangentially groove at circumfere near center height. You can change the groove geometry a little by raising the end mill face over the centre line of the rotating blank.

My drawing might be even more unclear...hope this helps.

Pekka

Navigation
Message Index

Go to full version