Gallery, Projects and General > The Design Shop

Truing diamond holder for TCG for surface grinding

<< < (2/3) > >>

PekkaNF:

--- Quote from: Alphawolf45 on January 29, 2019, 10:58:13 AM ---  I use a simple diamond holder.. Must also have angle/radius dresser in your kit...

--- End quote ---

First step to true the wheel. Gobbled up this one.

awemawson:
It'll do fine  :thumbup:

PekkaNF:
And it has worked - in several ocassions.

I was thinkking of "stocking up" few truing inserts and took a picture of the I have to assess the wear of it. Not much wear, clearly used, but still usable. However, it does not look like a "diamond". It was cheap, butt description said "diamond truing" etc.

No problem, because it seems to work on "blue" wheel.

BUT: Is there a prefered type of these or any ebayspecial will do?

Thank you

awemawson:
If it's harder than the stone then it'll work. No need to use the Crown Jewels  :thumbup:

PekkaNF:

--- Quote from: awemawson on February 10, 2019, 08:13:45 AM ---If it's harder than the stone then it'll work. No need to use the Crown Jewels  :thumbup:

--- End quote ---

Yea-but. No-but. :lol:

This is fine for this aluminium oxide - tested. But I have silicon oxide and harder wheels. Thinkking ahead - you know :)

Pekka

Navigation

[0] Message Index

[#] Next page

[*] Previous page