The Shop > CNC |
G01 bloqué sur f50 |
(1/1) |
rayfredo:
bonjour je suis nouveau dans le forum,et j'ai besoin d'aide j'ai un controleur RMHV2.1 mais l'avance programmé reste toujours à 50mm quelque soit la valeur j'ai changé le firmware avec pandora , mais rien ne change, j'ai toujours le problème pouvez vous m'aider à résoudre ce problème un grand merci par avance cordialement rayfredo |
awemawson:
Rayfredo, Welcome to the forum, I hope some one will be able to help you with your specific issue. Almost exclusively the language used on this forum is English, and I'm sure that you will get a far better response were you to re-post your request translated into English. Mean while, would you like to post something in the Introductions section telling us a little about you ? Google Translate helps a lot: "Hello I am new to the forum, and I need help I have a controller RMHV2.1 but the programmed advance always remains at 50mm whatever the value I changed the firmware with pandora, but nothing changes, I still have the problem can you help me solve this problem a big thank you in advance cordially, rayfredo " |
seadog:
Bienvenue Rayfredo. |
Navigation |
Message Index |