Gallery, Projects and General > The Design Shop

DRO for Warco Major mill

<< < (8/10) > >>

PekkaNF:
And because this is somewhat disasembled, might as well check how true parts are.

I measured horisontal plane in 0,01 mm resolution, checked first with thick blue, knock off some raised edges and burrs and then checked with very thin blue.

The surface looks a litle unusual.

seadog:
I see a scraping project about to commence  :D

PekkaNF:
No no no...this is good enough now. I'll use it as it is until it starts acting up. There is still a possibility that castings start to warp or something.

seadog:
I assume that you're hoping the castings will warp in the correct directions then, Pekka?  :lol:

PekkaNF:
I hope that castings will behave themselves.

The table looks pretty straight and contact between table/saddle is pretty civilized.

I don't have dovetail straight edge to check the guide ways properly, but looks ok.

Pekka

Navigation

[0] Message Index

[#] Next page

[*] Previous page