| Gallery, Projects and General > The Design Shop |
| DRO for Warco Major mill |
| << < (8/10) > >> |
| PekkaNF:
And because this is somewhat disasembled, might as well check how true parts are. I measured horisontal plane in 0,01 mm resolution, checked first with thick blue, knock off some raised edges and burrs and then checked with very thin blue. The surface looks a litle unusual. |
| seadog:
I see a scraping project about to commence :D |
| PekkaNF:
No no no...this is good enough now. I'll use it as it is until it starts acting up. There is still a possibility that castings start to warp or something. |
| seadog:
I assume that you're hoping the castings will warp in the correct directions then, Pekka? :lol: |
| PekkaNF:
I hope that castings will behave themselves. The table looks pretty straight and contact between table/saddle is pretty civilized. I don't have dovetail straight edge to check the guide ways properly, but looks ok. Pekka |
| Navigation |
| Message Index |
| Next page |
| Previous page |