| The Shop > Software Tools |
| Help with a DXF oddity please ! |
| << < (2/3) > >> |
| Spurry:
Andrew Could the stray circle be related to the origin of your drawing? If I open the drawing in Turbocad, the DXF displays without any problem, with and without the grid. Pete |
| awemawson:
Origin of the drawing is 0,0 |
| David Jupp:
Yep radius of the circles is 20mm. My guess is that AutoCAD and other software treat start/end angle differently. Both being zero probably gets interpreted as 'don't draw any of the arc' by AutoCAD, but as 'draw full circle' by others (on grounds that 0 = 360 ). The centre of the circles is at 0,0. |
| Chuck in E. TN:
The .dxf imported into Fusion 360 with no extra circles. The first time I imported it I had the dimension units set to imperial and the spanner was huge in length, but thin as paper. Changed units to mm and all's well. |
| needleworks:
I just opened the .dxf in Cambam > No circle. I then tried Solidworks > The circle is there. |
| Navigation |
| Message Index |
| Next page |
| Previous page |