Gallery, Projects and General > How do I??
Power supply for Nema 23 Stepper ?
mc:
--- Quote from: Buell on November 30, 2018, 05:13:22 PM ---Checked 0 volts on the terminal next to it so just shift the wire to that terminal and leave the other end at the driver thats has connections on ENA+ DIR+ AND PUL +?
--- End quote ---
Yes. That way the ENA on the driver should have a permanent connection to 0V and 5V.
Buell:
Nothing Now !
Buell:
locks up with power ON and Off but no movement
mc:
Just need to clarify this.
Did you move the wire that was connected to the ENA terminal on the controller, or a different wire?
Your + terminals on the driver, should still be connected to the outer Chinese writing terminal (this being your common 5V supply).
You then want to connect the ENA- wire from the driver to the inner Chinese writing terminal (which should be your common 0V/Gnd connection)
I suspect we've got out wires crossed, and you've moved the + terminals to 0V and is why you're now getting nothing.
Buell:
Your prob correct ! The ENA- at the moment goes to another terminal in the controller marked EN....IM guessing I dont need this one !
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version