Gallery, Projects and General > How do I??
Power supply for Nema 23 Stepper ?
Buell:
Got it going heres a vid
Hope its ok to post here ?
Buell:
This is what I ended up with as a visual just In case it didn't make sense. Well it doesn't to me !
Buell:
One draw back to this wiring....It doesn't Lock The motor !! Any ideas ? I would need it to lock to stop it from moving In the mill.
philf:
Buell,
You'd need to keep the enable input grounded to keep the motor powered to hold it. If your control board doesn't do that just put a switch in the enable line to switch the input to your driver from the control board to 0v.
Phil.
Buell:
--- Quote from: philf on November 30, 2018, 02:35:56 AM ---Buell,
You'd need to keep the enable input grounded to keep the motor powered to hold it. If your control board doesn't do that just put a switch in the enable line to switch the input to your driver from the control board to 0v.
Phil.
--- End quote ---
Exactly how do i do that ? On the power supply the + output goes to the GND on the stepper driver (Just that doesn't make sense to me , Ground has always been Earth to me )
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version