| Gallery, Projects and General > How do I?? |
| Power supply for Nema 23 Stepper ? |
| << < (4/13) > >> |
| Buell:
Got it going heres a vid Hope its ok to post here ? |
| Buell:
This is what I ended up with as a visual just In case it didn't make sense. Well it doesn't to me ! |
| Buell:
One draw back to this wiring....It doesn't Lock The motor !! Any ideas ? I would need it to lock to stop it from moving In the mill. |
| philf:
Buell, You'd need to keep the enable input grounded to keep the motor powered to hold it. If your control board doesn't do that just put a switch in the enable line to switch the input to your driver from the control board to 0v. Phil. |
| Buell:
--- Quote from: philf on November 30, 2018, 02:35:56 AM ---Buell, You'd need to keep the enable input grounded to keep the motor powered to hold it. If your control board doesn't do that just put a switch in the enable line to switch the input to your driver from the control board to 0v. Phil. --- End quote --- Exactly how do i do that ? On the power supply the + output goes to the GND on the stepper driver (Just that doesn't make sense to me , Ground has always been Earth to me ) |
| Navigation |
| Message Index |
| Next page |
| Previous page |