Gallery, Projects and General > Project Logs

Miniature coil winder

<< < (5/8) > >>

tom osselton:
It should still run in ok.

Doc:
Tested the transmission gear train with a small 12v dc motor. And here are the results.

tom osselton:
Gears seem to have worked out good nice work so far!

Doc:
Thanks Tom
Well getting down to the finish but I did have a error some where. The wire guide I made from a hypodermic needle and some spring steel but ended up to long and would be to close to the spool. So I need to shorten it and I also missed the feed hole in the one side plate.
Once I get those errors fixed I'll get the counter mounted and the motor and I'll be ready for a trial run. 

Doc:
Getting close to the first coil wind and we will see if I end up with a usable coil or not. Always wanted to try this so it will be new to me. I'll need to build a vacuum chamber for it next.

 

=45

Navigation

[0] Message Index

[#] Next page

[*] Previous page