| Gallery, Projects and General > Project Logs |
| Miniature coil winder |
| << < (5/8) > >> |
| tom osselton:
It should still run in ok. |
| Doc:
Tested the transmission gear train with a small 12v dc motor. And here are the results. |
| tom osselton:
Gears seem to have worked out good nice work so far! |
| Doc:
Thanks Tom Well getting down to the finish but I did have a error some where. The wire guide I made from a hypodermic needle and some spring steel but ended up to long and would be to close to the spool. So I need to shorten it and I also missed the feed hole in the one side plate. Once I get those errors fixed I'll get the counter mounted and the motor and I'll be ready for a trial run. |
| Doc:
Getting close to the first coil wind and we will see if I end up with a usable coil or not. Always wanted to try this so it will be new to me. I'll need to build a vacuum chamber for it next. =45 |
| Navigation |
| Message Index |
| Next page |
| Previous page |