The Shop > Tools
Keats angle plate, the other alternative to a four jaw chuck.
CrewCab:
--- Quote from: Brass_Machine on May 29, 2009, 02:31:03 PM ---I have a faceplate... want one those angle plates!
Eric
--- End quote ---
Eric, I live 20 minutes drive away from RDG, I can get you one and post it if you like.
CC
bogstandard:
I didn't mention this time that they can be bolted or clamped to your mill table to hold things perfectly vertical for milling, or can also be used on a surface grinder or shaper for doing the same thing. Or even on your surface plate for marking up. Can't think of anything else just yet, but I am sure there are a lot more uses.
It is a real universal tool.
Bogs
Brass_Machine:
--- Quote from: CrewCab on May 29, 2009, 02:46:42 PM ---Eric, I live 20 minutes drive away from RDG, I can get you one and post it if you like.
CC
--- End quote ---
We may end up doing that... probably be a few months before I can get the cash together.
Eric
PTsideshow:
Eric here is the contact for the US version called a Riker vise.
http://madmodder.net/index.php?topic=444.msg1237#msg1237
its plans to make one.
glen
John Hill:
--- Quote from: bogstandard on May 29, 2009, 04:55:36 AM ---My four jaw is massive and too heavy for me to lift safely, and until I get my new donated chuck mounted up, this will do me just fine.
Bogs
--- End quote ---
It is your own fault Mr Bogs, if you let me buy you that lathe in the damaged crate you could have had your four jaw permanently mounted on one! :beer:
Mind you I do agree they are darn heavy, I put mine of the floor once but never again, now it is either on the lathe or on its special shelf which is the same height. :med:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version