| The Shop > Tools |
| Keats angle plate, the other alternative to a four jaw chuck. |
| << < (2/4) > >> |
| CrewCab:
--- Quote from: Brass_Machine on May 29, 2009, 02:31:03 PM ---I have a faceplate... want one those angle plates! Eric --- End quote --- Eric, I live 20 minutes drive away from RDG, I can get you one and post it if you like. CC |
| bogstandard:
I didn't mention this time that they can be bolted or clamped to your mill table to hold things perfectly vertical for milling, or can also be used on a surface grinder or shaper for doing the same thing. Or even on your surface plate for marking up. Can't think of anything else just yet, but I am sure there are a lot more uses. It is a real universal tool. Bogs |
| Brass_Machine:
--- Quote from: CrewCab on May 29, 2009, 02:46:42 PM ---Eric, I live 20 minutes drive away from RDG, I can get you one and post it if you like. CC --- End quote --- We may end up doing that... probably be a few months before I can get the cash together. Eric |
| PTsideshow:
Eric here is the contact for the US version called a Riker vise. http://madmodder.net/index.php?topic=444.msg1237#msg1237 its plans to make one. glen |
| John Hill:
--- Quote from: bogstandard on May 29, 2009, 04:55:36 AM ---My four jaw is massive and too heavy for me to lift safely, and until I get my new donated chuck mounted up, this will do me just fine. Bogs --- End quote --- It is your own fault Mr Bogs, if you let me buy you that lathe in the damaged crate you could have had your four jaw permanently mounted on one! :beer: Mind you I do agree they are darn heavy, I put mine of the floor once but never again, now it is either on the lathe or on its special shelf which is the same height. :med: |
| Navigation |
| Message Index |
| Next page |
| Previous page |