| Gallery, Projects and General > Gallery |
| Electronic z height set tool |
| (1/2) > >> |
| Doc:
I've been wanting an electronic z height set tool for awhile but the ones I seen were all 2 inch high I wanted a 1 inch height so I made my own today. I'm happy with the way it turned out. Kind of made it up as I went along so I didn't take any video but did take some pics after the fact. |
| awemawson:
Nice Doc! Don't make the mistake that I did with mine, and forget that diamond doesn't conduct. I wiped out a nice diamond drag engraver tip by over travel. |
| efrench:
How does it set the height? CNC or manual mill? |
| philf:
Hi George, Is the top spring loaded or solid? The one I made for my CNC has 2mm overtravel. Phil. |
| Doc:
The top is spring loaded is will work on manual mill or NC. I usually write my programs for my NC with a home zero position of 1. This will save me a step of touching off and moving up 1.0 and zeroing. That is one the reasons I wanted a 1.0 not a 2.0. I don't have any diamond tooling but if I do end up with some I'll keep that in mind thanks for the tip I guess I would have done the same thing. |
| Navigation |
| Message Index |
| Next page |