After admiring Stew`s handiwork, today I made a small running centre for my 7x20 Mini Lathe.....
Whatever I`ve missed here, please refer to Stew`s posting........
The centre & MT2 blank to suit my smaller tailstock.
Blank mounted in MT3 sleeve in headstock. Remembering to insert a piece of 10mm screw into the blank`s thread, for stripdown.
Roughing began....... At .010" per pass.....
A little hard at the taper end.
Found a nice new "10mm" reamer.
A little swarfe clearing problem. (No problem).
This is not a good time to realise you do not own a drift.......
I then realised the reamer is a few microns undersize, so I polished the centre shank to a lovely "pop" fit.
This caused an airlock with the loctite...... Had to file a flat to allow the air out!
Just needs the taper shortening for the little tailstock, after the loctite has cured.
The centre is 23mm o/d, the tailstock ram is 22mm........ Now that`s close enough for me!
Thanks Stew! Yer a gem......
David D