Gallery, Projects and General > Project Logs
Taper attachment build
WeldingRod:
And after all that, who can resist a proper builder's plate!
S. Heslop:
Nice work. The scale and plate are a really nice touch.
It's also interesting to see a rapid prototyper being used for rapid prototyping!
vtsteam:
Wow, what a great project! Nice work :clap: :clap:
What will you use it for first? Any ideas?
WeldingRod:
I still haven't cut anything yet... project #1 is either cutting some 1" drills down to MT2 or making a hardinge nose taper for a balancing jig.
Sent from my SAMSUNG-SM-G891A using Tapatalk
PekkaNF:
Very nice! Did you got any play?
Where did that descrepancy crep in with the cross slide and taper attachment deck height?
--- Quote from: WeldingRod on August 12, 2018, 11:33:59 PM ---I relieved the center to make fit up a bit easier.
Installed on the lathe with the plastic bits on top.
Crud. A little higher than planned. At least those parts aren't made yet...
--- End quote ---
My speciality is to add a part thickness with wrong sign....latest was to add 20 mm instead of subsract it and even put the part in wrong way, because it did not look right - and then welded it solid. :D
Pekka
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version