« previous next »
Pages: [1]   Go Down

Author Topic: Hi from Germany  (Read 8987 times)

Offline hdo27

  • Jr. Member
  • **
  • Posts: 7
Hi from Germany
« on: July 09, 2018, 03:10:30 AM »
Hi all,

i'm from Germany and own a DIY cheap CNC machine i'm looking to replace
my current CNC setup based on Arduino GRBL and bCNC with a offline CNC
controller (DDCSV2.1)

Regards,

hdo
Logged

Offline awemawson

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 8998
  • Country: gb
  • East Sussex, UK
Re: Hi from Germany
« Reply #1 on: July 09, 2018, 05:13:31 AM »
Hi HDO, welcome aboard, do let us know about your CNC machine and what you are doing with it.

Lots of support here on the forum
Logged
Andrew Mawson
East Sussex

Offline vtsteam

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 6485
  • Country: us
  • Republic of Vermont
Re: Hi from Germany
« Reply #2 on: July 09, 2018, 12:00:45 PM »
Hi hdo, welcome!  :wave:
Logged
I love it when a Plan B comes together!
Steve
https://www.youtube.com/watch?v=4sDubB0-REg

Offline krv3000

  • Hero Member
  • *****
  • Posts: 2186
  • Country: gb
Re: Hi from Germany
« Reply #3 on: July 09, 2018, 05:20:05 PM »
hi and welcome
Logged

Offline hdo27

  • Jr. Member
  • **
  • Posts: 7
Re: Hi from Germany
« Reply #4 on: July 10, 2018, 02:49:02 AM »
Thanks all!

I build a CNC machine out of plywood which was featured in the Germany edition of the Make magazine (2014).
The build was done in a local maker space nearby.

I also own a small german youtube channel featuring my machine :-)

https://www.youtube.com/channel/UCAxtKPCrl_JZVNRNzqVIZ6g

However it's been a while since i did anything with the machine :-(

Just bought a DDCSV controller for my machine and can't wait to play around with it ;-)

Regards,

hdo

Logged
Pages: [1]   Go Up
« previous next »