The Craftmans Shop > New from Old
The Sequel - Oh Blimey I bought a CNC Lathe (Beaver TC 20)
awemawson:
I made it a few years back after Ade made mammoth chunks for his dry sump machining - thread here I think:
https://www.madmodder.net/index.php/topic,7213.msg77229.html#msg77229
I got hold of a sack of plastic injecting pellets they were MDPE and I bought candle wax pellets in large quantities on eBay. IIRC it was about a 50:50 mix and gentle warming, wax first then stir in the MDPE.
Some people use actual candles and plastic bags.
AdeV:
--- Quote from: awemawson on March 10, 2021, 04:35:33 PM ---Some people use actual candles and plastic bags.
--- End quote ---
Been there, done that....
I used some plastic pellets I bought from a supplier (they were LDPE rather than medium density), and some scrap candle wax I bought off eBay to make mine. Ratio is 4:1 wax to plastic, although there's plenty of scope for variation. I think the late John Stevenson compared a sample of mine with some commercial stuff, mine was a bit softer, but not a lot in it.
awemawson:
I've used plastic milk bottles, cut up blue water main, and eventually some injection moulding chips from the Polypipe factory used to make underground water fittings.
Thinking about it I seem to remember that I got my wax pellets from you Ade :scratch:
It all machines nicely but sharp edges can be fragile.
Muzzerboy:
Sounds as if polythene / LDPE actually dissolves in paraffin wax if you heat it. Is that the case? The thermometer in that other thread suggested 170C. You live and you learn!
awemawson:
Yes, heat the wax up to melt it and slowly stir in your chosen plastic.
You have to be careful not to set the wax on fire by heating too fast !
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version