A little bit more progress today:
I wanted to prove the PSU was OK but only the +5 volt output had test points. I was fairly sure that it also was supposed to put out +15 v and -15 v. Pulling the PSU apart it's only output connector is a three row 96 pin Eurocard type. I was surprised to find that mains for the 240 volt rack fans is routed via this connector. Inside I found a pair of 15 volt regulators confirming my suspicion, and also a Ferranti Uncommitted Logic Array - in a PSU for goodness sake WHY ?
Soldering a pair of 'wire wrap' square gold plated pins to my test probes I was able go along the crate back board and find the 15 volt lines powered up, so that's looking good.
Then I turned my attention to some of the card retaining screws that had sheared off. They are M4 but have an extended outer part with a hand grip, and a turned down section to retain them in the card. Drilling tapping and Loctiting replaced the sheered threads.
Then it was a case of 'hunt the battery' The one in the back of the monitor was easy - it's an SL2770 and RS Components carry it. However the one on the little RAM card proved more elusive. The original is in far too bad a shape to take reliable measurements from, but eventually I found an image on the web that revealed all - it's an SL886. There are two versions, one with pins and one with pads, and the original and the image I found don't help the diagnosis, so I will wait until the replacement card arrives to see which before I order.
Strangely the data sheet for the SL886 give it's weight as 21 grams, and my ruptured one weighs EXACTLY 21 grams despite all that death and destruction that it has oozed
![:scratch:](https://madmodder.net/Smileys/default/icon_scratch.gif)
Apart from posting pleas for help on Practical Machinist and CNC Zone that's about it for today.