The Craftmans Shop > New from Old
The Sequel - Oh Blimey I bought a CNC Lathe (Beaver TC 20)
seadog:
Love the spelling :doh:
awemawson:
Yes it is a bit hit and miss isn't it. I've noticed that on several of the Beaver documents
russ57:
--- Quote from: awemawson on September 06, 2018, 06:36:06 AM ---Strange - it's marked as Public :palm:
Maybe it need time to cook :scratch:
later edit: I've just tried the YouTube video on the Wife's iPad (so that I'm not logged in) and it shows fine
--- End quote ---
I usually use tapatalk, no worries usually. But that video doesn't even appear as a link.
But it is there from the website...
Russ
awemawson:
Although when I set the machine to cut a thread 'in the air' it appeared to be cutting correctly, now I've been brave enough to cut metal (and actually mount a threading tip, and measure it's offsets, it is obvious that all is NOT well. It looks to me as though the spindle rotation is not synchronised to the Z travel. Presumably the controller should wait for a reference point in the rotation before firing off the Z movement whereas the two look to be asynchronous to me.
I'd not be a bit surprised to eventually find that this is tied to the M19 spindle orientation problem that I'm having. Diagnostically it might just be a blessing in disguise, but then it might just be a pain in the neck :lol:
This is supposed to be an M12 x 1.75 mm pitch thread !
charadam:
Is it supposed to be a LH thread?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version