The Craftmans Shop > New from Old
Rebuilding A Grotty Chicken Shed
awemawson:
Time has come to reunite the base and upper works - but how? Well a handy Railway Axle Jack gave me a hand bringing it down in stages. Slightly tricky balancing act but I got away with it :ddb:
awemawson:
OK we got away with that, so now fix the two together. Simple 90 mm Paslode nails, but also i thought it prudent to put some 'builders banding' between to two for a bit of tensile strength.
Then it was just a case of sawing planks to length and nailing them on and going round with the creosote spray both inside and out. That should get rid of any lingering Red Mite :clap:
awemawson:
So was it all worth the effort - well in my opinion no - I still think it should have been burnt - but . . . . . . . :bang:
And of course now there is Chicken Shed #2 waiting in the wings expecting sorting :( :( :( :( :bang: :bang:
This shed I had made possibly 20 years ago to house my first 'male menopause event' the purchase and restoration of a 1952 Sunbeam S8 motor-cycle. Reliving my youth as I had one when I was a late teenager.
I found some pictures of it when we moved house to here back in 2007 - it's certainly deteriorated since then
(It's snuggling between my Thwaites 2 ton dumper truck and a Blacksmiths Power Hammer :lol:)
awemawson:
So how it it now 11 years on from the move, when it wasn't new then. Answer pretty grotty and rat eaten.
It has two doors and I plan to eliminate the one in the longer side, and re-plank at least three sides. The side away from the sun has survived quite well. The frame isn't in too bad a state, and as long as the nails pull out of the frame without making too much damage it 'should' be relatively straight forward. Famous last words :bugeye:
hermetic:
Cracking job on the henhut Andrew, hope you remembered to set the tracking after you fitted the wheels!
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version