Gallery, Projects and General > The Design Shop
Spiral Bevel Gears
RussellT:
This has been bugging me since you first posted it, but I have finally remembered another source of spiral bevel gears. They can also be found in the gearbox at the bottom of outboard motors. I'm fairly sure I have the gears from a 6hp motor somewhere. I'll try and dig them out later today to check on the ratio.
Russell
Joules:
That is good to know Russell, suspect the gears might be a tad large for my little mill. Would still be interested to have dimensions though, bet someone else would also have a use sooner or later.
RussellT:
Here are a couple of pictures. The ratio is 26:15 or 1.73:1
Russell
Joules:
Mmmmm, the ratio is workable and size smaller than I imagined. This does look promising...
kayzed1:
Sorry the gears i thought i had have gone walkabout..
Good luck.
Lyn.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version