The Craftmans Shop > New from Old
Rebirth of a Denford MIRAC CNC Lathe
awemawson:
Thanks chaps :thumbup:
This mornings job was to glue the trolley base back together having had to cut it apart to fit in the van.
Turns out not only were three of the castors missing their tyres, but they were welded on. So - cut off old castors - do a bit of weld preparation - weld the frame back together overcoming the inevitable springing out of alignment with some innovative clamping - then drill and tap for replacement castors.
.... what could be simpler :ddb:
DICKEYBIRD:
Might I suggest to the master titivator the addition of a couple or 3 geodesic braces to the base? :bow: :beer:
PekkaNF:
Loosely...396,49 € tax incl.
http://makersupplies.dk/motion-controllers/312-acorn-4-axis-motion-control-w-free-pc-software.html
Don't know that shop, I was looking for a stepper motor with 8 mm shaft and remembered this thread. Would this be cheaper from EU?
Pekka
awemawson:
So the afternoons task - put it back on the trolley and start the clean up. Just a rough first pass to get the bigger clods out !
krv3000:
a job well dun I need a stand making for me mill
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version