| Gallery, Projects and General > How do I?? |
| Rotary Table / Chuck Adaptor. |
| << < (3/4) > >> |
| sbwhart:
Well done that man :clap: it seems to be working out fine, pleased you found a use already for the little centre. Stew |
| Stilldrillin:
I have finally finished this project & completed it`s first piece of work...... :wave: Centre locating plug, tapped through 10mm for removal with chuck in situ, if necessary. Countersunk chuck screws. Why does Chester`s catalogue quote 63mm pcd........ When it is 66mm? :scratch: They didn`t catch me out..... This time! :D Countersunk adaptor screws..... To clear my faceplate. Then I realised I will be tightening through the slots...... ::) I fitted the assembly, then clocked a component in chuck jaws. Within .0015, before tapping true & final tightening! First job..... Drilling 1mm air holes in SEL steam engine wick holders. :thumbup: Just a bit pleased..... :D David D |
| bogstandard:
--- Quote ---Just a bit pleased..... --- End quote --- So you should be David. Very nice job, plus you have added another string to your bow, and a little more workshop tooling. :thumbup: :clap: John |
| sbwhart:
Nicely done and shown David :thumbup: It certainly is an advantage being able to fit you're chuck to the RT. Have fun :D Stew |
| Darren:
They look very nicely done David, Now I know how I'm going to tackle one of my little engine tasks :thumbup: |
| Navigation |
| Message Index |
| Next page |
| Previous page |