Gallery, Projects and General > Scraping

Lapping

<< < (3/3)

j1312v:
That is a nice haul Paul  :thumbup:,

Specially that small mag-chuck  :drool:

If you don't need the whole plate you can split it in to 2 or 4 smaller plates  :dremel:(depending of what are you looking to lap in the future) and make a set of lapping plates (rougher and finisher or course, medium, semifinish and finisher).

For your surface gauges you only need a nice flat surface and a bit of fine emery. Remember to use white spirits or wd40 as a lubricant and clean the parts after lapping.

Keep up the good work.  :beer:

Bernie

Navigation

[0] Message Index

[*] Previous page