Gallery, Projects and General > How do I??
Mini lathe motor. Once again.....
Stilldrillin:
Hello, Eric!
I fitted a new pot, early this year. Very easy to do. And, much better speed control, afterwards.
The only problem.... The locating hole, in the control box, is much too large.
I glued the pot in place. With silicone sealer..... :thumbup:
Brass_Machine:
I had to do some turning, luckily, the controller I built for the CNC mill worked as a stand in. Finding the pot is a pita!
Stilldrillin:
--- Quote from: Brass_Machine on December 22, 2017, 10:54:39 AM --- Finding the pot is a pita!
--- End quote ---
The speed control? How so? :scratch:
Or..... Do you mean, locating, a new pot?
John Rudd:
Could you post a picture of your speed control board or its part/model number?
It could be either a Sieg or a KB or summat else....
No blown fuses? No loose wires.....?
Stilldrillin:
Is this what you're needing, John?
No blown fuses. No pops/ bangs/ magic smoke...
The very gentle, facing cut, finished. And, the chuck spun to a standstill..... :scratch:
Which was why, I thought it was a brush problem.
Checking, with the light bulb. This afternoon. The "usual", initial few seconds of power, didn't happen...
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version