| Gallery, Projects and General > How do I?? |
| Mini lathe motor. Once again..... |
| << < (2/6) > >> |
| Stilldrillin:
Hello, Eric! I fitted a new pot, early this year. Very easy to do. And, much better speed control, afterwards. The only problem.... The locating hole, in the control box, is much too large. I glued the pot in place. With silicone sealer..... :thumbup: |
| Brass_Machine:
I had to do some turning, luckily, the controller I built for the CNC mill worked as a stand in. Finding the pot is a pita! |
| Stilldrillin:
--- Quote from: Brass_Machine on December 22, 2017, 10:54:39 AM --- Finding the pot is a pita! --- End quote --- The speed control? How so? :scratch: Or..... Do you mean, locating, a new pot? |
| John Rudd:
Could you post a picture of your speed control board or its part/model number? It could be either a Sieg or a KB or summat else.... No blown fuses? No loose wires.....? |
| Stilldrillin:
Is this what you're needing, John? No blown fuses. No pops/ bangs/ magic smoke... The very gentle, facing cut, finished. And, the chuck spun to a standstill..... :scratch: Which was why, I thought it was a brush problem. Checking, with the light bulb. This afternoon. The "usual", initial few seconds of power, didn't happen... |
| Navigation |
| Message Index |
| Next page |
| Previous page |