Gallery, Projects and General > Gallery
A little something for the evening Sir...
RobWilson:
--- Quote from: philf on December 03, 2017, 03:39:22 PM ---
--- Quote from: RobWilson on December 03, 2017, 02:29:28 PM ---Nicely done Joules :thumbup:
That looks a hand bit ok kit :dremel:
Rob
--- End quote ---
Hey up Rob - nice to see you back!
Phil.
--- End quote ---
Evening Phil, you got the CNC lathe running :poke:
Anyways just popped in for a look see. :coffee:
Cheers Rob
philf:
--- Quote from: RobWilson on December 04, 2017, 03:36:47 PM ---
--- Quote from: philf on December 03, 2017, 03:39:22 PM ---
--- Quote from: RobWilson on December 03, 2017, 02:29:28 PM ---Nicely done Joules :thumbup:
That looks a hand bit ok kit :dremel:
Rob
--- End quote ---
Hey up Rob - nice to see you back!
Phil.
--- End quote ---
Evening Phil, you got the CNC lathe running :poke:
Anyways just popped in for a look see. :coffee:
Cheers Rob
--- End quote ---
Hi Rob,
Maybe if you get your CNC mill finished it will inspire me! :poke:
I bought a cheap surface grinder earlier this year which is now clean and in grey primer but it's all in bits and I need a bigger mill to attempt to correct the wear in the knee.
Cheers.
Phil.
RobWilson:
--- Quote ---Hi Rob,
Maybe if you get your CNC mill finished it will inspire me! :poke:
--- End quote ---
:lol: Aye one day I will get back on with it Phil :dremel:
Navigation
[0] Message Index
[*] Previous page
Go to full version