| The Shop > Tools |
| Alba 1a shaper question |
| (1/2) > >> |
| Rick O Shea:
Hello All, I recently bought a Alba No1 shaper and have a bit of a question about the clapper box assembly, I have removed the box assembly and now would like to remove what I presume is the rotating assembly that holds the clapper box on to the arm. I have removed both the screws but the rotating section is incredibly tight and I cannot remove it. I wonder if any one could offer some advice and if possible a scan of the parts drawings showing that bit. very best wishes Mike |
| mattinker:
I don't know if you'ii have to join the Yahoo shaper group to acess the files section, but there is an Alba 1a shaper manual in there! https://groups.yahoo.com/neo/groups/Metal_Shapers/files Cheers, Matthew |
| mattinker:
I've been rooting around a bit and I've found the Elliot10m manual, the Alba is the previous model, and is pretty similar. On the pic below, part N°20 is the locking pin for the swivel, it has to be removed before you can remove the tool holder head. Cheers, Matthew |
| Rick O Shea:
Thanks Matthew its that part 20 I cannot remove I have removed the shaft locking screws but cannot push out the cross locking shaft. I might have to go up a hammer size. many thanks the drawing is perfect. Mike |
| mattinker:
Something tells me you have to turn it round to line it up to get t out!! Thinking about it, you may have to tun the tool holder base round to get the locking cam out. Try that before the next size of hammer. I took mine apart back in the last century, so my memory is a little vague to say the least! Good luck, Matthew |
| Navigation |
| Message Index |
| Next page |