Home Base > Introductions
Hello
JRow16:
:wave: I've been reading this forum and have realised that I'm a beginner even though I've been using a micro mill for a couple of years :D.
Ive been scaffolding for the past 3 decades and I'm about to go into semi retirement. That should give me more time to tinker.
I've been using a sieg xl1 and a tiny proxxon but I am planning on buying a bigger mill, probably a sieg sx2.7.
Ive also tried a bit of home anodising with mixed results and hope to improve on this.
awemawson:
Welcome aboard JRow16 :thumbup:
We all have to start somewhere - none of us were born with machining experience. Many here will offer you lots of good advice - you only have to ask. Remember - the only silly question is the one that you DON'T ask
mexican jon:
Welcome Aboard JRow16 :wave: :wave:
krv3000:
hi and welcome
Mike E.:
Hello, and Welcome !
Navigation
[0] Message Index
[#] Next page
Go to full version