| Home Base > Introductions |
| Hello |
| (1/2) > >> |
| JRow16:
:wave: I've been reading this forum and have realised that I'm a beginner even though I've been using a micro mill for a couple of years :D. Ive been scaffolding for the past 3 decades and I'm about to go into semi retirement. That should give me more time to tinker. I've been using a sieg xl1 and a tiny proxxon but I am planning on buying a bigger mill, probably a sieg sx2.7. Ive also tried a bit of home anodising with mixed results and hope to improve on this. |
| awemawson:
Welcome aboard JRow16 :thumbup: We all have to start somewhere - none of us were born with machining experience. Many here will offer you lots of good advice - you only have to ask. Remember - the only silly question is the one that you DON'T ask |
| mexican jon:
Welcome Aboard JRow16 :wave: :wave: |
| krv3000:
hi and welcome |
| Mike E.:
Hello, and Welcome ! |
| Navigation |
| Message Index |
| Next page |