« previous next »
Pages: [1]   Go Down

Author Topic: Hello  (Read 6241 times)

Offline JRow16

  • Newbie
  • *
  • Posts: 1
  • Country: gb
Hello
« on: September 05, 2017, 03:00:02 PM »
 :wave: I've been reading this forum and have realised that I'm a beginner even though I've been using a micro mill for a couple of years :D.
Ive been scaffolding for the past 3 decades and I'm about to go into semi retirement. That should give me more time to tinker.
I've been using a sieg xl1 and a tiny proxxon but I am planning on buying a bigger mill, probably a sieg sx2.7.
Ive also tried a bit of home anodising with mixed results and hope to improve on this.
Logged

Offline awemawson

  • Global Moderator
  • Hero Member
  • *****
  • Posts: 9015
  • Country: gb
  • East Sussex, UK
Re: Hello
« Reply #1 on: September 05, 2017, 03:09:57 PM »
Welcome aboard JRow16  :thumbup:

We all have to start somewhere - none of us were born with machining experience. Many here will offer you lots of good advice - you only have to ask. Remember - the only silly question is the one that you DON'T ask

Logged
Andrew Mawson
East Sussex

Offline mexican jon

  • Full Member
  • ***
  • Posts: 214
  • Country: england
Re: Hello
« Reply #2 on: September 05, 2017, 03:51:13 PM »
Welcome Aboard JRow16  :wave:  :wave:
Logged
People say you only live once ! I say thank F@*K can't afford to do it twice.

Offline krv3000

  • Hero Member
  • *****
  • Posts: 2188
  • Country: gb
Re: Hello
« Reply #3 on: September 05, 2017, 04:50:35 PM »
hi and welcome
Logged

Offline Mike E.

  • Jr. Member
  • **
  • Posts: 49
  • Country: us
Re: Hello
« Reply #4 on: September 05, 2017, 06:08:11 PM »
Hello, and Welcome !
Logged
Mike

California & Wales  - Home, & Home Away

Offline Biggles

  • Full Member
  • ***
  • Posts: 236
  • Country: gb
Re: Hello
« Reply #5 on: September 14, 2017, 12:05:11 AM »
Hi and Welcome JRow16  :coffee:
Logged
Pages: [1]   Go Up
« previous next »