| Gallery, Projects and General > Project Logs |
| Minnie on the cheap! |
| << < (13/17) > >> |
| NormanV:
Then it was onto my homemade milling machine with my homemade rotary table to try to cut my first gear! It bloody worked!!!! I did not get the cutter exactly at centre height but it was certainly good enough for me. The next ones will be better. |
| NormanV:
I've just cut the second gear, irt is also good. I could get addicted to this! |
| NormanV:
I am becoming an expert! |
| tom osselton:
Way to go! I haven't tried a gear yet but we did pick up a cutter a while back on ebay so it's somewhere in the stars. |
| NormanV:
Here we are! A complete set of Minnie gears. It needed a lot of attention so as not to make any mistakes. I managed to be one hole out on one of the teeth as the blades on the rotary table slipped, but when it goes through the worm wheel the error is somewhat reduced. |
| Navigation |
| Message Index |
| Next page |
| Previous page |