Gallery, Projects and General > The Design Shop
Engraving cutter sharpening
chipenter:
I bought a set of ten tc engraving cutters from China , and have broken the tips from five so far , I made a simple jig to sharpen and put a relife angle on them , 1/2" Whit tread as it is turned in it puts the relife on , and any cutting angle is easely set , these are 20 degrees I hope these will last longer .
awemawson:
A very neat idea using a coarse thread to create the relief - I must remember that one :thumbup:
Fergus OMore:
I'm looking over my copy of the Norman Tinker drawings and would be delighted to see more of it.
Perhaps you could oblige?
Thank You
Norm
John Stevenson:
Do not try to use these cutters as is from China they are far too sharp
You need to take a single swipe with a diamond slip angled back a couple of degrees and sideways a couple so you have less of a point, more the flat you get with your 12 degree attachment
TBH I still prefer HSS for fine work, far more forgiving
chipenter:
I was reliving the tip John but anything more than 0.2mm cut on brass and the tip went , 20 degrees gives a cleaner cut and the tip is still sharp , I will expriment further but still calling it a sucess .
Navigation
[0] Message Index
[#] Next page
Go to full version