Gallery, Projects and General > Oooops!
Indexing Dial
chipenter:
Out of over 300 lines of G code I put a C insted of an X , turn it off and start again .
Pete.:
Arg, I hate it when that sort of thing happens.
Seems like a lot of lines of code for such a repetitive task Jeff.
chipenter:
100 lines on the dial x+ x- e+3.6 three moves per line on the dial , very first job on the mini mill still learning big time .
sparky961:
--- Quote from: chipenter on July 09, 2017, 09:30:23 AM ---100 lines on the dial x+ x- e+3.6 three moves per line on the dial , very first job on the mini mill still learning big time .
--- End quote ---
This is a perfect application for a macro. If you tell us what controller/gcode type, there's a good chance I could offer assistance creating a short one.
chipenter:
This is Arduino running Marlin and does not support M98 call macro , wrote it with word pad copy and paste a block at a time , if I knew how to put the numbers I would do that but will have to stamp them .
Navigation
[0] Message Index
[#] Next page
Go to full version