| Gallery, Projects and General > Project Logs |
| Repeat-o-meter |
| (1/6) > >> |
| mattinker:
Revised video! Here is a video about a Repeat-o-meter that I have just built. it is for checking surface plates for hollows in the surface. This build is directly related to the 91cm x 91cmx 15cm granite surface plate that I just bought in preparation for scraping and the Richard King Scraping class in December! I have also been following a Tom Lipton John sanders collective build of the same tool. i realise that I didn't give an explanation about why I used the lathe to grind the feet flat, I don't have a big belt sander or a surface grinder, so it was the only way to get all four "feet" flat! Curious to have your thoughts, regards, Matthew |
| awemawson:
I'm looking forward to seeing this in the flesh in December Matthew. (BTW I'm getting a 12 minute gap from 30 m to 42 m on playing your video) |
| mattinker:
Thanks Andrew! |
| mattinker:
Ooops! I've made a mistake in the editing, thought I'd checked it through! So I'll swap out the the bad for the good video as soon as I can redo the mix! Sorry about that! regards, Matthew. |
| PekkaNF:
VERY nice! Thank you for showing. I found the mentioned first part, but haven't seen the second part yet. Pekka |
| Navigation |
| Message Index |
| Next page |