Gallery, Projects and General > How do I??
poorly seig c3
John Rudd:
Ok, so we know your level, we can guide you if you provide the info .... :zap:
Just dont go hurting yourself....240v isnt nice... :lol:
davidcurtis021:
--- Quote from: John Rudd on June 06, 2017, 05:27:17 PM ---Ok, so we know your level, we can guide you if you provide the info .... :zap:
Just dont go hurting yourself....240v isnt nice... :lol:
--- End quote ---
i thought it might help if i provided a diagram showing what i did yesterday as i don't have the proper terminology in my vocablary. possibly make it easier to understand and see where i have made blunders
that is not the number on my control board but the layout is the same in preview the picture looks too small to read apologies for that but i dont know how to make it larger.
john i have also taken the readings you suggested which from the left pin 008.9 centre pin 0 right pin 000.1 regarding the range button pressing it moved the decimal place to the right.
thank you for the patience which you have shown thus far
John Rudd:
So, do you have 5volts dc measured at the connector on the little power supply?
Can you post up a photo of your speed control board please?
davidcurtis021:
--- Quote from: John Rudd on June 07, 2017, 05:22:06 AM ---So, do you have 5volts dc measured at the connector on the little power supply?
Can you post up a photo of your speed control board please?
--- End quote ---
i dont know about the voltage at the 5v connector when i went to measure i was getting inttermitent readings after which i discovered that the inline fuseholder had broken at the end so i had to suspend work till a new one arrives from arc eurotrade which will hopefully arrive tommorow
did take a picture of the control board though which is below.
John Rudd:
So, are you now thinking that the broken fuse holder is the reason why your machine isnt operational?
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version