Home Base > Introductions
Hello from Kent!
krv3000:
hi and welcum
chipenter:
Welcom wereabouts in Kent are you ? freindly lot hear , I would offer to help with the install but can't lift mutch at the moment .
Biggles:
Welcome neighbour, Harrison has a lot of representation here. Love to see flying lathe! :wave:
PS, I doubt it will get an air worthiness certificate!! :nrocks:
farmerjoe:
Hi guys,
Lot of response! Been very busy at work and forgot to check back.
I'm based on the farm that I live and work on in Penshurst, near Tonbridge.
Unfortunately I didn't take any pictures, to focused on squeezing it in! I think my helper took some photos though. I'll find out.
I've given it a bit of a clean up and some minor adjustments and it's got pretty much zero backlash and is nice and tight on all the slides. Much better than I thought it was going to turn out!
Haven't used it yet as I need to run improved electrics out to the "workshop" as what's there can't cope with the start up load. Should get that done maybe by then end of the week if not next.
Now looking at milling machines! Something like a Centec 2A with vertical head would be spot on for the space I have available now the lathes in.
Atb,
Joe
awemawson:
You're practically a neighbour Joe, just up the A21 a bit :thumbup:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version